AFBMW ReAMP 3

Audison ReAMP3 plug and play cable BMW with Hifi sound system and RAM 

This Plug&Play T-Harness allows to install an Audison AF bit amplifier on BMW vehicles equipped with RAM modules. It is compatible with "Standard" and "HI-FI" 676 sound systems (It is also compatible with 688 HK-branded systems, but only delivers 7 of the 9 channels required). This harness delivers the 7 speaker-level outputs of the RAM to the inputs of your AF amplifier and also provides speaker leads for front, rear, underseat woofer, and center - so you can configure your AF amplifier as desired. NOTE: not compatible with AP BMW ASD BYPASS – Active Sound “artificial exhaust note” defeat requires vehicle coding.

The DCC solution, (Direct Cockpit Current) can be used combined with the AP bit amplifiers’ feature which controls the amplifier absorption peaks, protecting the car power supply system.

"For BMW models for 2019 without RAM module use the ReAMP 1 cable"

AFBMW ReAMP 3 allows to:

1. Compatibility with RAM module-equipped 676 HiFi audio package and Audison AF bit Forza amplifier.

2. Use the Hi-level input configuration #11 (2-way front + rear + center) during the bit Drive Wizard configuration process. This is essential to properly route the input signal to the bit processor section.

3. Confirm proper application APBMW ReAMP 1, APBMW ReAMP 2 and AFBMW ReAMP 3 use identical connectors, but with different pinouts. They are not interchangeable.

4. 676 HiFi systems use 2Ω woofers. Do not bridge two channels into a 2Ω load, since protection shutdown or amplifier damage may result. To use bridged channel replace the OEM 2Ω woofers with Audison APBMW S8- 4.2 4Ω woofers.

5. Please check after installing and setup the input wizard if the balance rear left and right is oke, otherwise change this in the cable or in the input mixer.