AMPIRE CAC300

This CAN bus interface you can install a car alarm or remote start systems in a modern car with up to three different CAN databus lines. The CAC300 interface can be installed in many vehicles. Before the installation, the CAC300 need a vehicle-specific firmware. To upload the firmware, you need the BL600 boot loader and a computer with USB port.


The following functions are possible depending on the type of vehicle:

CLOSE ALL DOOR
OPEN ALL DOORS
OPEN TRUNK
BLINKERS SEQUENCE STEERING
START ENGINE
STOP ENGINE
DRIVERS DOOR SIMULATION
FOOTBRAKE
KEY INSERT
IGNITION
ENGINE WORKING
SPEED 10KMPH
HAND BRAKE
SWITCHES COMBINATION
UNLOCKING BY FACTORY REMOTE
LOCKING BY FACTORY REMOTE
ARMING STATUS
FACTORY ALARM++
HOOD
TRUNK
PASSENGERS DOOR
DRIVERS DOOR
ALTERNATIVE CENTRAL LOCK CONTROL
BLINKERS ALTERNATIVE CONTROL


Important note:
Please check with the car list in the download section which vehicles are compatible. Not all features are on all vehicles and technically possible, of course, depending on equipment. Please check after installation if no malfunction and whether the data bus after falling asleep at least 45 minutes. The current draw of the locked vehicle before and after the installation of CAC300 should not increase significantly.


SPECIFICATIONS
External module voltage: 12V
Current draw on standby: 0,90 mA
Current draw when working: 28,00 mA 40,00 mA
Operating temperature range: -40°C +85°C
Number of analog input: 10
Number of analog output: 18
Number of supported CAN buses: 3
Speeds readed from digital buses: 33,33 kb/s 500 kb/s
Dimensions; 84,2 x 35,6 x 15,0 mm
Weight; 93g
E20 97R01/08 004015 00